12. FX TRACK PARAMETERS

12. FX TRACK PARAMETERS · PDF p. 62 · OS 1.40A

# 12. FX TRACK PARAMETERS

12. FX TRACK PARAMETERS
12. FX TRACK PARAMETERS
Here follows a description of the parameters that are on the FX track’s PARAMETER pages. The FX track
controls the parameters of the Analog FX block and in addition it also gives sequencer control over the
parameters on the REVERB and DELAY parameter pages. For more information, please see “13. DELAY,
REVERB AND MIXER PARAMETERS” on page 68. The FX track’s parameters are saved together with
the pattern. The parameters may be locked to other settings on any step of the pattern by first pressing and
holding a [TRIG] key, then changing the parameters settings with the DATA ENTRY knobs. For more infor
mation, please see “9.10.1 PARAMETER LOCKS” on page 43.
12.1 EDITING THE FX TRACK PARAMETERS
Press the [FX] key to access the FX track and then use the [PARAMETER] keys to access the different PA
RAMETER pages. Use the DATA ENTRY knobs A-H to change the parameters. Press and hold a [PARAME
TER] key to see the values for all parameters on that page.
12.2 TRIG PARAMETERS PAGE
Set the actions for what a trig on the FX does. These general settings affect trigs placed in the sequencer.
Use the DATA ENTRY knobs to change the settings.
Press [TRIG PARAMETERS] to access this parameter page.
12.2.1 LEN
Trig Length sets the length of the trig. In LIVE RECORDING mode, the duration of pressing the [TRIG]
keys overrides this general setting.
12.2.2 PROB
Trig Probability sets the probability that the trigs on the track plays or not. The probability outcome is
re-evaluated every time a trig plays. The default setting is 100%, meaning that all the trigs on the track
plays every time.
This parameter changes temporarily to display and control COND (Trig Condition) when you add a condi
tional lock. COND sets the Trig Condition with which a set of conditional rules can be applied to any trig,
using a parameter lock. For more information, please see “9.10.3 TRIG CONDITIONS AND CONDITION
AL LOCKS” on page 44.
If you have placed a conditional lock on a trig in the sequencer, the trig condition overrides
the Trig Probability setting. For example, if you set PROB to 70% and a FILL trig condition
on a trig, that trig will only (and always) play when the Syntakt is in FILL mode.
12.2.3 LFO.T
LFO Trig controls if the LFO will be trigged or not.
12.2.4 FLT.T
Filter Trig controls if the filter envelope will be trigged or not.
12.2.5 AMP.T
Amplifier Trig controls if the FX tracks amplifier envelope will be trigged or not.
12.3 SYN PARAMETERS PAGE
On this page you can set the set the amount of analog drive on the FX track. For more information, please
see “5.4 ANALOG FX BLOCK” on page 17.
Press [SYN] to access this parameter page.

Chunks share pages with neighboring sections; text before/after the section heading belongs to the adjacent sections.