12.5 FLTR PAGE 2

12. FX TRACK PARAMETERS > 12.5 FLTR PAGE 2 · PDF p. 64 · OS 1.40A

# 12.5 FLTR PAGE 2

12. FX TRACK PARAMETERS
TIME
AMPLITUDE
Note On
Attack
Decay
Sustain
Note Off
Release
Env.
Delay
12.5 FLTR PAGE 2
On FILTER page 2, you will find the parameters that control the envelope delay parameter. Press [FLTR]
twice to access this parameter page.
12.5.1 DEL
Envelope delay sets the time before the attack phase of the filter envelope starts. This parameter is part
of the filter envelope that controls the multimode filter. You can also press and hold [FUNC] and then
turn DATA ENTRY knob A to quickly access this parameter from FILTER page 1.
12.5.2 FENR
FIlter envelope reset sets the filter envelope behavior:
ON resets the envelopes for each consecutive trig.
OFF does not reset the envelopes for each consecutive trig.
12.5.2 FPAN
Filter Pan adjusts the cutoff frequency of the filter and pans its behavior between the Left and Right
channel. At a value of 0 there is no frequency panning effect. Lower values increase the cutoff frequency
in the Left channel and decrease it in the Right channel. Higher values increase the cutoff frequency in
the Right channel and decrease it in the Left channel.
12.6 AMP PAGE 1
The AMP page 1 controls parameters for the inverted amplitude envelope, effects sends, panning and
volume.
Press [AMP] to access this parameter page.
12.6.1 ATK
Attack Time sets the length of the attack phase of the amp envelope.

Chunks share pages with neighboring sections; text before/after the section heading belongs to the adjacent sections.