← 返回搜索

12.4 CHORUS

12. FX AND MIXER PARAMETERS > 12.4 CHORUS · PDF 第 67 · OS 1.10D

# 12.4 CHORUS

12. FX AND MIXER PARAMETERS
HPF
HPF sets the cutoff frequency of the reverb high-pass filter that affects the audio going into the reverb.
LPF
LPF sets the cutoff frequency of the reverb low-pass filter that affects the audio going into the reverb.
12.4 CHORUS
(SEND FX PAGE 3)
The chorus can be used to widen sounds, enhance the stereo image or add subtle movement to sounds.
DPTH
Depth sets the depth of the LFO modulation of the chorus.
SPD
Speed sets the speed of the LFO modulation of the chorus.
HPF
High-pass filter sets the highpass filtering of the input signal.
WDTH
Width sets the stereo width of the chorus.
VOL
Chorus Volume sets the volume of the Chorus output signal. Use LEVEL/DATA to set this parameter.
DEL
Delay Send sets how much of the wet chorus signal to send through to the delay.
REV
Reverb Send sets how much of the wet chorus signal to send through to the reverb.
12.5 COMPRESSOR
(MIXER PAGE 1)
The Compressor master effect compresses the dynamic range of the signal by reducing the volume of loud
sounds relative to the quiet sounds. There are eight parameters with which the compressor is customized
on this page. There is a bar on the left side of the screen that visually represents the amount gain reduction
THR
Threshold sets the threshold of the compressor. A lower threshold means a larger portion of the signal is
subject to compression.

章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。