11. THE TRACK SETUP MENU

11. THE TRACK SETUP MENU · PDF 第 50 · OS 1.3.3

# 11. THE TRACK SETUP MENU

11. THE TRACK SETUP MENU
11. THE TRACK SETUP MENU
The TRACK SETUP menu contains several setup pages related to the active track, its behavior, and setup.
You can access specific TRACK SETUP menu pages (or page groups) by using [FUNC] + [PARAMETER
PAGE] keys. Depending on which PARAMETER key you selected, you open the setup pages related to
the primary function of that parameter key. You can also navigate between the different pages within the
TRACK SETUP menu using the [PARAMETER PAGE] keys. If a page group has more than one page, you
use the group’s [PARAMETER PAGE] key to cycle through the pages. Use [UP] and [DOWN] to move
between the options. Use [LEFT] and [RIGHT] to select settings or press [YES] to open sub-menus. Press
[NO] to exit the menu.
11.1 TRIG
Here you can set several note and trig-related parameters. Press [FUNC] + [TRIG] to directly access this
page. These settings are only available for audio tracks (Track 1–8).
11.1.1 PLAY MODE
Here, you can set whether a preset is polyphonic or monophonic and whether the LFOs for each voice
are synced or not. This setting is not availble for the Subtracks machine.
POLY The Sound is polyphonic, and the LFOs for each voice are running independently of each other.
POLY M.LFO In POLYPHONIC WITH MONO LFO mode, the preset is polyphonic, and the LFOs for
each voice are synced together with the first voice LFO. The LFO of the first voice played determines
the cycle of the LFOs, and the subsequently played voices’ LFOs are synced to this cycle. This makes
the LFO behave like a single or monophonic LFO. This is useful, for example, if you want to use the
LFO for a tremolo effect.
MONO The preset is monophonic, and the envelope is always triggered by each note on, or key press.
MONO LEG. In this mode, the preset is monophonic; however, the envelopes are not triggered by a
subsequent note or key press if the first note is still held.
11.1.2 MONO NOTE PRIO
Here, you can set the note priority, i.e., which note is played if more than one note is played simultaneous
ly. This setting is only available if PLAY MODE is set to MONO or MONO LEG. This setting is not availble
for the Subtracks machine.
LAST gives priority to the last note played.
LOW gives priority to the lowest note played.
HIGH gives priority to the highest note played.
11.1.3 REUSE VOICES
Sets if the same note played twice should reuse the same voice, or cycle to use another free voice.
ON Reuses the same voice. Useful for staccato effects and drums.
OFF Cycles to use another voice. Suitable for piano-like sounds and pads.
11.1.4 CHOKE GROUPS
Here you can assign a Subtracks machine’s individual subtracks to one of two choke groups.
Choking is a sound design technique where one track cuts off the sound of one or more other tracks
within the same choke group. Fist you assign which tracks should be in the choke group, then when a
track withing the group is triggered, all the other tracks in the same choke group receive a note-off mes
sage and are silenced immediately—their normal envelope release is skipped and replaced with a very
short release.

章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。