12.13 MOD PAGE 2 (VOICE LFO 2)
12. AUDIO TRACK PARAMETERS > 12.13 MOD PAGE 2 (VOICE LFO 2) · PDF 第 60 · OS 1.3.3
# 12.13 MOD PAGE 2 (VOICE LFO 2) 12. AUDIO TRACK PARAMETERS • ONE The LFO starts when a note is trigged, then runs to the end of the waveform and then stops. This makes the LFO function similar to an envelope. • HALF The LFO starts when a note is trigged, then runs to the middle of the waveform and then stops. DEP Depth sets the depth and polarity of the LFO modulation. Both negative and positive modulation depths are possible. A center setting, 0.00, equals no modulation depth. 12.13 MOD PAGE 2 (VOICE LFO 2) MOD page 2 contains the same parameters as VOICE LFO page 1, but controls VOICE LFO 2. 12.14 MOD PAGE 3 (MOD ENVELOPE) The Mod Envelope can be used to modulate track parameters. It is similar to the envelopes on the AMP and FLTR pages but lets you route to a destination of your choice. ATK Attack Time sets the length of the attack phase of the amp envelope. DEC Decay Time sets the length of the decay phase of the amp envelope. SUS Sustain Level sets the sustain level of the amp envelope. REL Release Time sets the length of the release phase of the amp envelope. RSET Mod Envelope Reset sets the Mod envelope behavior: ON resets the envelope for each consecutive trig. The envelope’s attack phase is reset to zero. OFF does not reset the envelopes for each consecutive trig (default). The envelope’s attack phase continues from where it was left off. DEST Destination selects the modulation destination for the Mod Envelope. Preview how the modulation will affect the sound by highlighting a destination. Press [YES] to confirm the selection. Press [NO] to cancel and revert to previous selection. For more information, please see “APPENDIX B: LFO/MOD ENVELOPE MODULATION DESTINATIONS” on page 113. DEP Depth sets the depth and polarity of the Mod Envelope modulation. Both negative and positive modula tion depth is possible. A center setting, 0.00, equals no modulation depth. 12.15 MOD PAGE 4 (FX LFO 1) The FX Low-Frequency Oscillators can be used to modulate the parameters of the selected Insert FX 1 and 2. This page controls the behavior of FX LFO 1. SPD Speed sets the speed of the LFO. Try settings of 8, 16 or 32 to sync the LFO to straight beats. The knob is bipolar. The LFO cycle can be played backward by using negative values.
章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。