11.7 AMP PAGE

11. TRACK PARAMETERS > 11.7 AMP PAGE · PDF p. 60–62 · OS 1.12

The AMP page controls parameters for the amplitude envelope, panning, and volume.

Press [AMP] to access this parameter page.

ATK

Attack Time sets the length of the attack phase of the amp envelope.

HOLD

Hold Time sets the length of the hold phase of the amp envelope. Fixed Hold time values (0–126) specify the length of the hold phase, and the envelope ignores Note Off events such as Trig Length, releasing a [TRIG] key or a key on an external controller. Setting HOLD to NOTE means the hold phase will be determined by Note On and Note Off events. This parameter is only available if MODE is set to AHD. If you set HOLD to NOTE and use an external keyboard to trigger the envelope, then the sound will be sustained (if DEC is set to less than 127) for as long as you press a key on the keyboard.

DEC

Decay Time sets the length of the decay phase of the amp envelope.

SUS

Sustain Level sets the sustain level of the amp envelope. This parameter is only available if MODE on is set to ADSR.

REL

Release Time sets the length of the release phase of the amp envelope. This parameter is only available if MODE is set to ADSR.

RSET

Amp envelope reset sets the amp envelope behavior:

ON resets the envelope for each consecutive trig (default). The envelopes attack phase is reset to zero.

OFF does not reset the envelopes for each consecutive trig. The envelopes attack phase continues from where it was left off..

MODE

Envelope mode sets the amplitude envelope to function as an AHD or an ADSR envelope.

PAN

Pan positions the audio in the stereo field.

VOL

Volume sets the volume amount of the amplifier. Unlike the track LEVEL, this parameter can be parameter locked. and is saved with the preset. Amplitude envelope with MODE set to AHD and a fixed HOLD time.

TIME

AMPLITUDE

Note On

Attack Decay Hold Note Off

Attack Decay Hold Note On

Note Off

Attack Decay Hold Note On Note Off

Amplitude envelope with MODE set to AHD and HOLD set to NOTE.