12.4 FLTR PAGE 1
12. FX TRACK PARAMETERS > 12.4 FLTR PAGE 1 · PDF p. 63–64 · OS 1.40A
# 12.4 FLTR PAGE 1 12. FX TRACK PARAMETERS 12.3.8 DRIVE Drive sets the amount of analog drive that is added to the audio routed through the FX track. Yes, it goes to 11! 12.4 FLTR PAGE 1 On FILTER page 1, you will find the parameters that control the analog multimode filter and its associated envelope. Press [FLTR] to access this parameter page. 12.4.1 ATK Attack Time sets the length of the attack phase of the filter envelope. 12.4.2 DEC Decay Time sets the length of the decay phase of the filter envelope. 12.4.3 SUS Sustain Level sets the sustain level of the filter envelope. 12.4.4 REL Release Time sets the length of the release phase of the filter envelope. 12.4.5 FREQ Frequency sets the cutoff frequency of the multimode filter. 12.4.6 RESO Resonance sets the resonance behavior of the filter. Resonance introduces a peak in the spectrum at the cutoff frequency. 12.4.7 TYPE Filter Type selects the type of filter. (4-pole Lowpass, 2-pole Lowpass, Bandpass, Highpass, Notch, Dou ble-Notch, Lowpass-Notch, OFF) 12.4.8 ENV Env. Depth sets the amount of cutoff frequency modulation from the filter envelope. The knob is bipolar, both negative and positive modulation depths are available. 12. FX TRACK PARAMETERS TIME AMPLITUDE Note On Attack Decay Sustain Note Off Release Env. Delay 12.5 FLTR PAGE 2 On FILTER page 2, you will find the parameters that control the envelope delay parameter. Press [FLTR] twice to access this parameter page. 12.5.1 DEL Envelope delay sets the time before the attack phase of the filter envelope starts. This parameter is part of the filter envelope that controls the multimode filter. You can also press and hold [FUNC] and then turn DATA ENTRY knob A to quickly access this parameter from FILTER page 1. 12.5.2 FENR FIlter envelope reset sets the filter envelope behavior: ON resets the envelopes for each consecutive trig. OFF does not reset the envelopes for each consecutive trig. 12.5.2 FPAN Filter Pan adjusts the cutoff frequency of the filter and pans its behavior between the Left and Right channel. At a value of 0 there is no frequency panning effect. Lower values increase the cutoff frequency in the Left channel and decrease it in the Right channel. Higher values increase the cutoff frequency in the Right channel and decrease it in the Left channel. 12.6 AMP PAGE 1 The AMP page 1 controls parameters for the inverted amplitude envelope, effects sends, panning and volume. Press [AMP] to access this parameter page. 12.6.1 ATK Attack Time sets the length of the attack phase of the amp envelope.
チャンクは隣接セクションとページを共有します。見出し前後のテキストは隣のセクションのものです。