13.5 MIXER PAGE 2
13. DELAY, REVERB AND MIXER PARAMETERS > 13.5 MIXER PAGE 2 · PDF p. 70–71 · OS 1.40A
# 13.5 MIXER PAGE 2 13. DELAY, REVERB AND MIXER PARAMETERS 13.3.5 HPF HPF sets the cutoff frequency of the reverb high-pass filter that affects the audio going in to the reverb. 13.3.6 LPF LPF sets the cutoff frequency of the reverb low-pass filter that affects the audio going in to the reverb. 13.3.7 VOL Mix Volume sets the volume of the Reverb output signal. The parameters on the REVERB parameter page can be controlled by the sequencer using the FX Track. For more information, please see “6.3.3 THE FX TRACK” on page 21. and “12. FX TRACK PARAMETERS” on page 62. 13.4 MIXER PAGE 1 The INTERNAL MIXER 1 page is where you can access the TRACK LEVEL parameters of the track 1–8 audio tracks. Press [FUNC] + [LFO] to access this parameter page. 13.4.1 TRK 1–8 Sets the TRACK LEVEL of track 1–8. A striped level bar indicates that the track is routed to the FX track. A MIDI jack symbol indicates that the track is using a MID machine. 13.5 MIXER PAGE 2 The INTERNAL MIXER 2 page is where you can access the TRACK LEVEL parameters of the track 9–12 audio tracks and the overall levels of the signals from the delay, reverb, and the incoming audio from exter nal sources via the INPUT L/R inputs. Press [FUNC] + [LFO] twice to access this parameter page. 13.5.1 TRK 9–12 Sets the TRACK LEVEL of track 9–12. A striped level bar indicates that the track is routed to the FX track. A MIDI jack symbol indicates that the track is using a MID machine. 13.5.2 FX Sets the overall level of the FX track. 13.5.3 DEL Sets the overall level of the delay. 13.5.4 REV Sets the overall level of the reverb 13. DELAY, REVERB AND MIXER PARAMETERS 13.6 MIXER PAGE 3 This page is used to set up the incoming external audio from INPUT L/R and to configure the routing of the audio from INPUT L/R in relation to the Analog FX block. For more information, please see “5.4 ANALOG FX BLOCK” on page 17. Press [FUNC] + [LFO] three times to access this parameter page. 12.3.1 IN LR Input LR Level sets the level of the audio from the INPUT L/R inputs. I can be configured as a mono or a stereo input. For more information please see “14.6.1 EXTERNAL IN” on page 79. 12.3.3 DEL Delay Send sets the amount of audio from the INPUT L/R inputs that is sent through to the delay effect. For more information, please see “13.2 DELAY” on page 68. 12.3.4 REV Reverb Send sets the amount of audio from the INPUT L/R inputs that is sent through to the reverb effect. For more information, please see “13.3 REVERB” on page 69. 12.3.2 BAL Balance sets the balance of the audio from the INPUT L/R inputs. 12.3.7 IN Input FX Routing sets if audio from the INPUT L/R inputs will be routed through the Analog FX block (PRE) or not (POST). For more information, please see “5.4 ANALOG FX BLOCK” on page 17.
チャンクは隣接セクションとページを共有します。見出し前後のテキストは隣のセクションのものです。