9. THE SEQUENCER
9. THE SEQUENCER · PDF 第 36 · OS 1.40A
# 9. THE SEQUENCER 9. THE SEQUENCER 9. THE SEQUENCER The sequencer of the Syntakt stores information in patterns. A pattern controls the playback of the audio/ MIDI tracks, the FX track, and various pattern-specific aspects of the tracks. Each of the eight banks, A to H, contains 16 patterns, which means 128 patterns are available for each project. For more information, please see “14.3 PATTERN” on page 73. A pattern contains: • General trig settings on the TRIG page (default note pitch, velocity et cetera). • The parameter settings on the SYN, FLTR, AMP, and LFO pages. • The settings on the DELAY, REVERB, and MIXER pages. • The parameter settings on the FX track. • Quantization settings. • Note trigs and Lock trigs for all tracks. • Parameter/sound locks. • Length and time signature for the tracks. 9.1 SEQUENCER TEMPO To change the BPM setting, open the TEMPO menu by pressing the [TEMPO] key. Use the LEVEL/DATA knob to change tempo. Pressing the knob while turning it changes the tempo four BPM at a time. The [ARROW] keys [UP] or [DOWN] change the tempo in increments of 0.1 BPM. Note that you can chose between a global tempo or using a separate tempo for every pattern. Press [FUNC] + [YES] to switch between GLOBAL and PATTERN tempo mode. On the main interface screen, you can also press and hold [ARROW] keys [LEFT] or [RIGHT] to nudge the tempo 10% up or down temporarily. Release the key to revert to the original tempo. To tap a tempo setting, hold the [FUNCTION] key and tap the [TEMPO] key in a steady rhythm. After four consecutive taps the average tempo of the taps will be calculated. By continuing tapping, the average tem po will keep on updating. When in the TEMPO menu (and with GLOBAL tempo mode selected), holding [FUNC] while turning the LEVEL/DATA knob will not change the tempo to the selected value until the [FUNC] key is released. While doing this, “PREP.” will flash in the bottom left corner of the screen. Nudging the tempo is very handy when manually syncing Syntakt to a turntable or an external sound source. Note that you do not need to be in the TEMPO menu to perform tempo nudging. 9.2 BASIC PATTERN OPERATIONS Syntakt can seamlessly switch between patterns. This, together with the ability to chain patterns, is a handy feature when improvising live. For more information, please see “9.11 CHAINS” on page 46. 9.2.1 SELECTING BANK AND PATTERN Press [PTN] and then use the [LEFT]/[RIGHT] keys to select a bank (if you want to select a pattern from another bank than the current). Then press [TRIG 1–16] to select a pattern. There is a secondary way to change bank and pattern, more similar to earlier Elektron devices. Press [BANK] and then press [TRIG 9–16] to select a bank. Then press [TRIG 1–16] to select a pattern. Press [PTN] and then press [TRIG 1–16] to select a new pattern in the current bank. . White [TRIG] keys indicate pattern positions that contain data. A red [TRIG] key indicates the current active pattern. Empty patterns are unlit. When a pattern is playing, and a new pattern is selected, the new pattern position will be shown flashing
章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。