← 返回搜索

11.3 SYN PAGE

11. MIDI TRACK PARAMETERS > 11.3 SYN PAGE · PDF 第 59 · OS 1.40A

# 11.3 SYN PAGE

11. MIDI TRACK PARAMETERS
11.2.6 LFO.T
LFO Trig controls if the LFO will be trigged or not.
11.3 SYN PAGE
Here you can set the MIDI channel that the MIDI track should use to send data. Bank and program change
values are also set here, together with a few standard CC parameters. The default value of the parameters
on this page is OFF, meaning they are disabled and will not send out any data. Press and hold [FUNC] and
then press the DATA ENTRY knobs to enable them. You can then use the DATA ENTRY knobs to set the
parameter values as usual. Disable the parameters by repeating the enabling procedure.
Press [SYN] once to access this parameter page.
11.3.1 CHAN
Channel sets the MIDI channel the track sends MIDI data to. If you set this parameter to OFF, it turns the
MIDI track off. Please note that this parameter cannot be parameter locked.
11.3.2 BANK
Bank sends a bank change message on CC 0 MSB.
11.3.3 SBNK
Sub Bank sends a bank change message on CC 32 LSB.
11.3.4 PROG
Program Change sends a Program Change message.
11.3.5 PB
Pitch Bend controls the pitch bend data sent on the MIDI track.
11.3.6 AT
Aftertouch controls the aftertouch data sent on the MIDI track.
11.3.7 MW
Mod Wheel controls the modulation wheel data sent on the MIDI track.
11.3.8 BC
Breath controller controls the breath control data sent on the MIDI track.
11.4 FLTR PAGE (CC VALUE)
Here you can set the values of up to eight assignable CC commands. The default value of the parameters
on this page is OFF, meaning they are disabled and will not send out any data. Press and hold [FUNC] and
then press the DATA ENTRY knobs to enable them. You can then use the DATA ENTRY knobs to set the
parameter values as usual. Disable the parameters by repeating the enabling procedure.
Press [FLTR] to access this parameter page.

章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。