← 返回搜索

13.1 EDITING THE DELAY, REVERB AND MIXER PARAMETERS

13. DELAY, REVERB AND MIXER PARAMETERS > 13.1 EDITING THE DELAY, REVERB AND MIXER PARAMETERS · PDF 第 68 · OS 1.40A

# 13.1 EDITING THE DELAY, REVERB AND MIXER PARAMETERS

13. DELAY, REVERB AND MIXER PARAMETERS
13. DELAY, REVERB AND MIXER PARAMETERS
The Syntakt effects and mixers parameters are explained in this chapter.
13.1 EDITING THE DELAY, REVERB AND MIXER PARAMETERS
The Syntakt’s Delay and Reverb are send effects and are set on a pattern level. It means that all the sounds
in a pattern shares the same effect settings but have individual send levels to the effects. The Delay and
Reverb parameters are set on their respective PARAMETER page, but their incoming signals are set by the
DEL and REV send parameters on the AMP page of each audio track. Press [FUNC] + [FLTR] to edit the
Delay. Press [FUNC] + [AMP] to edit the Reverb. Use the DATA ENTRY knobs A-H to change the parameters.
DELAY controls the character, reverb send and volume of the delay send effect.
REVERB controls the character and volume of the reverb send effect.
The FX parameter settings are stored as part of the pattern. Don’t forget to save the pattern
and give it a unique name once you have achieved the results you want.
13.2 DELAY
The Delay send effect takes the input signal, delays it in time and then rejoins it with the original signal.
Press [FUNC] + [FLTR] to access this parameter page.
13.2.1 TIME
Delay Time sets the delay time. It is relative to the current BPM and is measured in 128th notes.
TIME setting
Divide ratio
1/128
1/64
2.67
1/48 (1/32T)
1/64.
1/32
5.33
1/24 (1/16T)
1/32.
1/16
10.67
1/12 (1/8T)
1/16.
1/8
21.33
1/6 (1/4T)
1/8.
1/4
42.67
1/3 (1/2T)
1/4.
1/2
1/2.

章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。