13.6 MIXER PAGE 3
13. DELAY, REVERB AND MIXER PARAMETERS > 13.6 MIXER PAGE 3 · PDF 第 71–72 · OS 1.40A
# 13.6 MIXER PAGE 3 13. DELAY, REVERB AND MIXER PARAMETERS 13.6 MIXER PAGE 3 This page is used to set up the incoming external audio from INPUT L/R and to configure the routing of the audio from INPUT L/R in relation to the Analog FX block. For more information, please see “5.4 ANALOG FX BLOCK” on page 17. Press [FUNC] + [LFO] three times to access this parameter page. 12.3.1 IN LR Input LR Level sets the level of the audio from the INPUT L/R inputs. I can be configured as a mono or a stereo input. For more information please see “14.6.1 EXTERNAL IN” on page 79. 12.3.3 DEL Delay Send sets the amount of audio from the INPUT L/R inputs that is sent through to the delay effect. For more information, please see “13.2 DELAY” on page 68. 12.3.4 REV Reverb Send sets the amount of audio from the INPUT L/R inputs that is sent through to the reverb effect. For more information, please see “13.3 REVERB” on page 69. 12.3.2 BAL Balance sets the balance of the audio from the INPUT L/R inputs. 12.3.7 IN Input FX Routing sets if audio from the INPUT L/R inputs will be routed through the Analog FX block (PRE) or not (POST). For more information, please see “5.4 ANALOG FX BLOCK” on page 17. 14. SETTINGS MENU 14. SETTINGS MENU The SETTINGS menu offers settings that affect Syntakt and can also be used to manage Projects. Press [SETTINGS] to access the SETTINGS menu. Scroll the list by using [UP]/[DOWN] or the LEVEL/ DATA knob. Open a highlighted menu by pressing [YES]. 14.1 PROJECT 14.1.1 LOAD PROJECT Load Project opens a project selection screen where you can choose a project to load. Note that the ac tive project will not be saved before loading the new project so remember to save the active project first. If you wish to create a new project, select CREATE NEW at the very bottom of the list. The new project will be a blank slate. If you load a new project it will replace the active project. Be sure to save your active project before you load another project. 14.1.2 SAVE PROJECT AS Save Project opens a project selection screen where you choose a slot to save the active project to. You can also press [FUNC] + [SETTINGS] to access this screen. 14.1.3 MANAGE PROJECTS Manage Projects launches the PROJECT MANAGER menu. Selecting a project in this menu and pressing the [RIGHT] arrow key will bring up a list of commands. CLEAR Resets the project slot to a clean state. DELETE Removes the project from the slot. RENAME Opens a NAMING screen where you can rename the project file. LOAD FROM Loads the selected project. This will replace the active project! SAVE TO Saves the active project to the selected slot. TOGGLE Toggles write protection on or off. Write protected projects cannot be overwritten, renamed or erased. A lock symbols in front of the project name shows that the project is write protected. INIT NEW Initializes an empty file slot with a clean project. This option is only available for empty proj ect slots. 14.2 SONG In this menu, you can perform tasks related to songs. You can also press [SONG MODE] + [UP] to open the SONG menu. For more information, please see “9.12 SONG MODE” on page 47
章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。