12.7 AMP PAGE

The AMP page controls parameters for the amplitude envelope, panning, and volume.

ATK

Attack Time sets the length of the attack phase of the amp envelope.

HOLD

Hold Time sets the length of the hold phase of the amp envelope. Fixed Hold time values (0–126) specify the length of the hold phase, and the envelope ignores Note Off events such as Trig Length, releasing a [TRIG] key, or a key on an external controller. Setting HOLD to NOTE means the hold phase will be determined by Note On and Note Off events. This parameter is only available if ENVELOPE MODE in the TRACK SETUP menu is set to AHD.

If you set HOLD to NOTE and use an external keyboard to trigger the envelope, the sound will be sustained (if DEC is set to a value less than 127) for as long as you press a key on the keyboard.

DEC

Decay Time sets the length of the decay phase of the amp envelope. When ENVELOPE MODE is set to AHD, DECAY works as the REL parameter, defining the time from end of HOLD to 0.

SUS

Sustain Level sets the sustain level of the amp envelope. This parameter is only available if ENVELOPE MODE in the TRACK SETUP menu is set to ADSR.

REL

Release Time sets the length of the release phase of the amp envelope. This parameter is only available if ENVELOPE MODE in the TRACK SETUP menu is set to ADSR.

OVER

Overdrive sets the amount of overdrive and clipping distortion of the signal entering the filter.

PAN

Pan positions the audio of each voice in the stereo field. The knob function is bipolar with 0 being the balanced midpoint, L64 sends all sound to the left channel and R63 sends all sound to the right.

VOL

Volume sets the volume amount of the amplifier. Unlike the track level (LEV), this parameter can be parameter locked and is saved with the preset. For the Subtracks machine, this parameter sets the amp level for every separate subtrack.

Press [FUNC] + [AMP] to access the TRACK SETUP menu and use the ENVELOP MODE setting to select if you want the AMP envelope to be in ADSR or AHD mode.