6.1 SCREEN NAVIGATION

6. INTERACTING WITH THE DIGITAKT II > 6.1 SCREEN NAVIGATION · PDF p. 18 · OS 1.15A

# 6.1 SCREEN NAVIGATION

6. INTERACTING WITH THE DIGITAKT II
6. INTERACTING WITH THE DIGITAKT II
The screen shows all the information needed for real-time interaction and editing on the Digitakt II. The
eight DATA ENTRY knob parameters shown will vary depending on the given situation. Below is the main
interface screen of the SRC page.
1. The current bank and pattern.
2. The current pattern name.
3. The selected TRIG mode.
4. The current tempo.
5. Eight track parameters. They show what the DATA ENTRY knobs control and their current parameter
values.
6. Parameter page indicator. Indicates the number of pages for the selected parameter section and which
page is currently selected.
7. The main level setting of the active track. Use the LEVEL/DATA knob to change the volume setting.
8. The current active track.
9. Track type. Audio (SMP) track or MIDI (MID) track.
The Digitakt II features a screen saver that dims the screen after 5 minutes of inactivity
and turns off the screen after 60 minutes. Press any key or move any controller to wake
the screen.
6.1 SCREEN NAVIGATION
Use the [ARROW] keys [UP], [DOWN], [LEFT] or [RIGHT] to navigate menus or sub-menus.
The LEVEL/DATA knob can be used to scroll through menus and lists quickly.
[YES] is used to affirm, select, enter sub-menus and tick/untick boxes.
[NO] is used to negate, deselect or go back one or more steps.
When in a menu or sub-menu, the [NO] key can be used to go back, one step at a time, all the
way to the main screen.
6.2 PARAMETER EDITING
The DATA ENTRY knobs are used to change the values of the track parameters. The positions of the pa
rameters on the screen correspond to the physical locations of the knobs on the front panel. Some of the
parameters on the screen tell you what DATA ENTRY knob controls that particular parameter.
For example “(E)” in the PAGE SETUP menu.
• The parameters are adjusted in larger increments if you press down the DATA ENTRY knob while turning
it. This makes it quicker to sweep through the whole parameter range.
• Press DATA ENTRY knob + [NO] to reset the parameter to the default value.
• Press [PARAMETER] key + [PLAY] to reset all the parameters in the selected parameter page to
default values.
• Press and hold a [PARAMETER] key to see the values for all parameters on that page.

チャンクは隣接セクションとページを共有します。見出し前後のテキストは隣のセクションのものです。