14.6 AUDIO ROUTING

Here you find number of audio routing options that affects the Digitakt II on a global level.

14.6.1 TO MAIN

Use this option to customize which of the 16 tracks, 3 effects (Delay, Reverb, Chorus), and inputs that will send audio to the MAIN OUT outputs. Press [YES] then use [UP]/[DOWN] to switch between the setup pages. Use the [TRIG] keys to activate/deactivate the tracks, effects, and inputs that can send to main. Green keys signal send to main. Unlit keys signal do not send to main.

14.6.2 TO FX

Use this option to customize which of the 16 tracks, 2 effects (Delay, Chorus), and inputs that will send audio to the effects. Press [YES] then use [UP]/[DOWN] to switch between the setup pages. Use the [TRIG] keys to activate/deactivate the tracks, effects, and inputs that can send to FX. Green keys signal send to FX. Unlit keys signal do not send to main.

14.6.3 USB IN

Sets where the incoming audio from Overbridge or a class compliant device is routed to in the Digitakt II’s signal path. This parameter is only available when USB CONFIG is set to USB AUDIO/MIDI. For more information, please see “14.8.1 USB CONFIG” on page 83.

MAIN the incoming audio is routed to the Digitakt II’s main outputs.

OFF No audio is routed from USB to the Digitakt II.

14.6.4 USB OUT

Sets from where in the Digitakt II’s signal path, the outgoing audio is routed to Overbridge or a class compliant device. This parameter is only available when USB CONFIG is set to USB AUDIO/MIDI. For more information, please see “14.8.1 USB CONFIG” on page 83.

MAIN the outgoing audio is routed from the Digitakt II’s Main out at the end of the signal path.

L:T1–16/R:T1–16 the outgoing audio is routed from the selected track(s) Press a [TRIG] key twice to select a single track as a stereo source. The selected track’s [TRIG] key lights up white.

Press first one [TRIG] key and then another to select two separate tracks as sources. The selected tracks’ [TRIG] keys lights up blue for left channel and red for right channel. The audio from each track is then summed to mono, routed out and sent separately on left and right channel.

EXT the outgoing audio is routed straight from the Digitakt II’s audio inputs IN L/R to Overbridge or a class compliant device.

OFF no audio is sent to Overbridge or a class compliant device.

14.6.5 INT TO MAIN

Sets if Digitakt II sends internal audio to the MAIN OUT and HEADPHONES OUT or not when used with Overbridge or as a class compliant audio device.

OFF No sound is sent to main out.

ON Sound is always sent to main out.

AUTO When USB audio streaming is active, no internal sound is sent to the main out. When USB audio streaming is inactive, sound is sent to the main out.

14.6.6 USB TO MAIN [dB]

Sets the amount of amplification of the sound that is streamed over USB to the Digitakt II main out when used with Overbridge or as a class compliant audio device. (0 dB–+18 dB)

14.6.7 PRE/POST FADER

Sets if audio over USB should be pre or post the track level setting.

• Audio from the TRACK OUTPUTS is always without any effects.
• Tracks that are routed to not send audio to MAIN OUT still send audio on separate outputs in Overbridge.