11.8 FX PAGE
11. TRACK PARAMETERS > 11.8 FX PAGE · PDF 第 57–58 · OS 1.15A
# 11.8 FX PAGE 11. TRACK PARAMETERS RSET Amp envelope reset sets the amp envelope behavior: ON resets the envelope for each consecutive trig (default). OFF does not reset the envelope for each consecutive trig. MODE Envelope mode sets the amplitude envelope to function an AHD or an ADSR envelope. PAN Pan positions the audio in the stereo field. VOL Volume sets the volume amount of the amplifier. Unlike the track LEVEL, this parameter can be parame ter locked. Amplitude envelope with MODE set to AHD and a fixed HOLD time. TIME AMPLITUDE Note On Attack Decay Hold Note Off Attack Decay Hold Note On Note Off Attack Decay Hold Note On Note Off Amplitude envelope with MODE set to AHD and HOLD set to NOTE. TIME AMPLITUDE Note On Attack Decay Hold Note Off Attack Decay Hold Note On Note Off Attack/ Hold Decay Note On Note Off 11.8 FX PAGE The FX parameter page contains a number of FX related parameters such as the Bit Reduction, Overdrive, and Sample Rate Reduction. Here you also find the send levels for the Delay, Reverb, and Chorus effects. Press [FX] to access this parameter page. 11. TRACK PARAMETERS BR Bit Reduction sets the bit rate. The parameter range is from 16 bits to 1 bit. OVER (Overdrive) sets the gain amount into the digital overdrive. SRR Sample Rate Reduction sets the amount of sample rate reduction. ROUT SRR Routing sets if the Sample Rate Reduction effect is applied pre (before) or post (after) the filter section. DEL Delay Send sets the amount of sound sent through to the Delay effect. For more information, please see “12. FX AND MIXER PARAMETERS” on page 61. REV Reverb Send sets the amount of sound sent through to the Reverb effect. For more information, please see “12. FX AND MIXER PARAMETERS” on page 61. CHR Chorus Send sets the amount of sound sent through to the Chorus effect. For more information, please see “12. FX AND MIXER PARAMETERS” on page 61. OD.RT Overdrive Routing selects if the overdrive effect is routed before (PRE) or after (POST) the filter machine. Please note that there are no parameters on the FX page for MIDI tracks. 11.9 MOD PAGE 1 The MOD pages contains three LFOs (two for tracks that use MIDI machines). The Low-Frequency Oscilla tor can be used to modulate the parameters found on the tracks SRC, FILTER and AMP pages. Customize the low-frequency oscillator behavior, orientation, and depth on this page. This page controls the behavior of LFO 1 Press [MOD] to access this parameter page. SPD Speed sets the speed of the LFO. Try settings of 8, 16 or 32 to sync the LFO to straight beats. The knob is bipolar. The LFO cycle can be played backward by using negative values. MULT Multiplier multiplies the SPD parameter by the set factor either by multiplying the current tempo (BPM settings), or by multiplying a fixed tempo of 120 BPM. FADE Fade In/Out makes it possible to fade in/fade out the LFO modulation. The knob is bipolar. Positive val ues give a fade-out, negative values give a fade in. 0 gives no fade in/fade out. (-64–63)
章节与相邻小节共享 PDF 页面；标题之前/之后的文本属于相邻小节。