14.6 AUDIO ROUTING (GLOBAL)

Here you find number of audio routing options that affects the Syntakt on a global level. You can also set the audio routing on a pattern level. For more information, please see “14.3.5 AUDIO ROUTING (PATTERN)” on page 74.

14.6.1 EXTERNAL IN

Sets if the incoming audio from INPUT L/R is treated as a stereo signal or two mono signals.

14.6.2 MAIN

Use this option to customize which of the 12 tracks + 2 effects (Delay, Reverb) that sends audio to the MAIN OUT outputs. Use the [TRIG 1–12] keys and the [FLTR], and [AMP] keys to activate/deactivate send from each track and effect. Green keys signal send to main. Red keys signal do not send to main.

14.6.3 SEND TO DEL/REV

Use this option to customize which of the 12 tracks + the Delay effect that sends audio to the effects (Delay, Reverb). Use the [TRIG 1–12] keys and the [FLTR] key to activate/deactivate send from each track and effect. Green keys signal send to the effects. Red keys signal do not send to the effects.

14.6.4 USB IN

Sets where the incoming audio from the class compliant device is routed to in the Syntakt’s signal path. This parameter is only available when USB CONFIG is set to USB AUDIO/MIDI. For more information, please see “14.9.1 USB CONFIG” on page 82.

PRE-FX the incoming audio is routed in before the Syntakt’s Analog FX block and will be affected by this and then be sent at the main outputs.

POST-FX the incoming audio is routed in after the Syntakt’s Analog FX block and will not be affected by this. The audio is then sent at the main outputs.

OFF No sound is routed from USB to the Syntakt.

14.6.5 USB OUT

Sets from where in the Syntakt’s signal path, the outgoing audio is routed to the class compliant device. This parameter is only available when USB CONFIG is set to USB AUDIO/MIDI. For more information, please see “14.9.1 USB CONFIG” on page 82.

MAIN the outgoing audio is routed from the Syntakt’s Main out at the end of the signal path.

TRACK 9–12, L:T9–12/R:T9–12 the outgoing audio is routed from the selected track(s) Press a [TRIG] key twice to select a single track as a destination. The selected track’s [TRIG] key lights up purple. Press first one [TRIG] key and then another to select two separate tracks as sources. The selected tracks’ [TRIG] keys lights up blue for left channel and red for right channel. The audio from the tracks is then routed out and sent separately on left and right channel.

EXT the outgoing audio is routed straight from the Syntakt’s audio inputs INPUT L/R to the class compliant device.

OFF no audio is sent to the class compliant device.

14.6.6 INT TO MAIN

Sets if Syntakt sends internal audio to the MAIN OUT and HEADPHONES OUT or not when used with Overbridge or as a class compliant audio device.

OFF No sound is sent to main out.

AUTO No sound is sent to main out when Overbridge is available and/or streaming audio, if not, the sound is sent to main out.

ON sound is always sent to main out.

14.6.7 USB TO MAIN [dB]

Sets the amount of amplification of the sound that is streamed over USB to the Syntakt main out when used with Overbridge or as a class compliant audio device. (0 dB–+18 dB)

14.6.8 PRE/POST FADER

Sets if audio over USB should be pre or post the track level setting.

• Audio from the TRACK OUTPUTS is always without any effects.
• Tracks that are routed to not send audio to MAIN OUT still send audio on separate outputs in Overbridge.